Dynasonics TFXP Series Transit Time Ultrasonic Flow Meter Manuel d'utilisateur Page 106
- Page / 132
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
TFX Error Codes
Revised 2-22-2002
Code Number Description Correction
Warnings
0001
Serial number not present Hardware serial number has become inoperative – system
performance will not be influenced.
0010
Signal Strength is below Signal
Strength Cutoff entry
Low signal strength is typically caused by one of the following:
• Empty pipe
• Improper programming/incorrect values
• Improper transducer spacing
• Non-homogeneous pipe wall
0011
Measured Speed of Sound in the liquid
is greater than 10% different than the
value entered during meter setup
Verify that the correct liquid was selected in the BASIC menu.
Verify that pipe size parameters are correct.
0020
Heat Flow Units of measure have been
selected and an RTD module has not
been installed
Verify that RTD Module PN D020-1045-106 has been installed
in one of the I/O meter slots. Verify that OUTPUT1 or OUTPUT
2 has been configured for RTD measurements.
Class C Errors
1001
System tables have changed Initiate a meter RESET by cycling power or by selecting
SYSTEM RESET in the SEC MENU.
1002
System configuration has changed Initiate a meter RESET by cycling power or by selecting
SYSTEM RESET in the SEC MENU.
Class B Errors
3001
Invalid hardware configuration Upload corrected file
3002
Invalid system configuration Upload corrected file
3003
Invalid strategy file Upload corrected file
3004
Invalid calibration data Recalibrate the system
3005
Invalid speed of sound calibration data Upload new data
3006
Bad system tables Upload new table data
3007
Data Logger is off or not present If desired, insert data logger and configure within the Datalog
Operations Menu. If logger is not present, configure I/O port for
no logger.
3010
One or more channels are not
responding (Multi-channel meters only)
Display indicates which secondary units are not communicating
with Master meter. Verify wiring, configuration and address of
secondary instrument.
3011
All channels are not responding (Multi-
channel meters only)
Verify wiring, configuration and address of secondary
instruments.
Class A Errors
4001
Flash memory full Return unit to factory for evaluation
- Series TFXP 1
- BEFORE OPERATING THE TFXP 3
- TABLE OF CONTENTS 4
- Location 6
- PART 1 - INTRODUCTION 10
- TFXP - A - 10
- PART 1 - SPECIFICATIONS 11
- Transmitter 12
- Installation 12
- Electrical 13
- Connections 13
- Battery 14
- Charging and 14
- External 14
- Sources 14
- General 15
- Information 15
- Regarding 15
- Input/Output: 15
- ISO-MODs 15
- Standard 16
- 4-20 mA 16
- Optional 17
- Data Logger 17
- ISO-Mods 17
- 1. Mounting Location 20
- Table 2.1 21
- 2. Transducer Spacing 22
- Transducer 23
- Mounting Mode 23
- Entering Pipe 24
- 3. Transducer Mounting 26
- Positioning 28
- Z-Mount 31
- Mounting 34
- 4. RTD INSTALLATION 36
- Insertion RTD 37
- Starting the 39
- Instrument 39
- Startup 39
- Operation 40
- Graphics 41
- Display 41
- Configuration 41
- Contrast 42
- Structure 42
- BSC MENU -- BASIC MENU 43
- Sound Speed 45
- Roughness 45
- Thickness 46
- Material 46
- Fluid Specific 49
- Heat Capacity 49
- Spacing 51
- Engineering 51
- ISO-MOD: 55
- (Optional) 55
- 2. DATALOG OPERATION MENU 56
- Logging 57
- Interval 57
- Duration 57
- 3. DATALOG MAINTENANCE 59
- 4. OUTPUT 2 MENU 62
- 4-20 mA Span 64
- Calibration 65
- 4-20 mA Test 67
- Rate Pulse 67
- K-Factor 68
- Programming 68
- Dual Relay 69
- Flow Rate 70
- Batch/Totalize 70
- SEN MENU -- SENSOR MENU 74
- SEC MENU -- SECURITY MENU 74
- SER MENU -- SERVICE MENU 75
- DSP MENU -- DISPLAY MENU 77
- Back Light 78
- Timeout 78
- PART 4 - SOFTWARE UTILITIES 79
- HEAT FLOW DDENDUM 100
- HEAT FLOW ADDENDUM 100
- APPENDIX 103
- BSC MENU 104
- DATALOG 104
- SER MENU 105
- OUT2 MEN 105
- SEN MENU 105
- SEC MENU 105
- DSP MENU 105
- TFX Error Codes 106
- 42,000 pulses per min 107
- 39,000 pulses per min 108
- = 99.1 GPM 109
- Fluid Properties 110
- Host protocol 118
- STANDARD CLASSES 122
- Copper & 125
- Brass Pipe 125
- ALUMINUM 125
- CONTACTS AND PROCEDURES 130
Produits connexes et manuels pour Équipement Dynasonics TFXP Series Transit Time Ultrasonic Flow Meter
(16 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.154 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels